In order to print the ring sizer above, be sure that your printer is set to 100%. Make sure that you have not reduced the print size in your printer 'page setup' area. You can verify that the sizer printed correctly by measuring it with a ruler; it should measure from A to B: 3 1/2 inches long.
Once you have printed the sizer, follow these directions to find your ring size:
- Cut out the ring sizer
- Cut a slit for Slot "A"
- With the numbers facing out, wrap the sizer around the finger where the ring will be worn.
- Pull the pointed end Tab "B" through Slot "A" until the sizer is snug. It helps to tape the end of the sizer to your finger so that you can pull it tight but make sure to allow size for the knuckle!
- The number aligned with Slot "B" is your ring size.
- If the measure lands between two numbers your size is a half size Ex: Between 5 and 6 ring size: 5.5. Please enter only whole or half sizes in the rize size box when ordering.
If you have any questions please do not hesitate to email Trevor O'Neil at trevor@tojogallery.com or Phone 773-726-4545
BACK TO RINGS CATALOG